{"model":"mk2","model_name":"MK2 Supra","vehicle":"Toyota Supra A60 (1982–1986, 5M-GE)","document":"Repair Manual","section":"IG","section_name":"Ignition System","page":10,"pages_in_section":10,"title":"Ignition System","section_header":"Ignition System — Distributor","ocr_text":"Check\nConnector\n\n2. ADJUST IGNITION TIMING\n(a) Connect a timing light to the engine.\n(b) Start the engine and run it at idle.\n(c) Short circuit the terminals of the check connector\nT and E1\n\n(d) Using a timing light, slowly turn the distributor until\nthe timing mark on the crankshaft pulley is aligned\nwith the 10° mark. Tighten the distributor bolt.\nIgnition timing: 10° BTDC@ (T and E1)\nTorque: 140 kg-cm (10 ft-lb, 14 N-m)\n(e) Unshort the check connector.","image":"https://tsrm.sasquatchvc.com/images/mk2/IG/IG_010.png","url":"https://tsrm.sasquatchvc.com/mk2/tsrm/IG/10","prev":{"page":9,"url":"https://tsrm.sasquatchvc.com/mk2/tsrm/IG/9","api":"https://tsrm.sasquatchvc.com/api/pages/mk2/tsrm/IG/9"},"next":null,"section_url":"https://tsrm.sasquatchvc.com/mk2/tsrm/IG","section_api_pages":["https://tsrm.sasquatchvc.com/api/pages/mk2/tsrm/IG/1","https://tsrm.sasquatchvc.com/api/pages/mk2/tsrm/IG/2","https://tsrm.sasquatchvc.com/api/pages/mk2/tsrm/IG/3","https://tsrm.sasquatchvc.com/api/pages/mk2/tsrm/IG/4","https://tsrm.sasquatchvc.com/api/pages/mk2/tsrm/IG/5","https://tsrm.sasquatchvc.com/api/pages/mk2/tsrm/IG/6","https://tsrm.sasquatchvc.com/api/pages/mk2/tsrm/IG/7","https://tsrm.sasquatchvc.com/api/pages/mk2/tsrm/IG/8","https://tsrm.sasquatchvc.com/api/pages/mk2/tsrm/IG/9","https://tsrm.sasquatchvc.com/api/pages/mk2/tsrm/IG/10"],"note":"OCR transcript of a scanned Toyota factory manual page; verify critical values (torque specs, part numbers) against the image."}