The procedures are presented in a step-by-step format: • The photo or illustration shows what to do and where to do it. • The task heading tells what to do. • The detailed text tells how to perform the task and gives other information such as specifications and warnings. Example: Photograph or Illustration: what to do and where Task heading: what to do 21. CHECK PISTON STROKE OF OVERDRIVE BRAKE (a) Place SST and a dial indicator onto the overdrive brake piston as shown in the figure. SST 09350-30020 (09350-06120) Set part No. Component part No. Detail text: how to do it (b) Measure the stroke applying and releasing the compressed air (4 – 8 kgf/cm², 57 – 114 psi or 392 – 785 kPa) as shown in the figure. Piston stroke: 1.40 – 1.70 mm (0.0551 – 0.0669 in.) Specification This format provides the experienced technician with a FAST TRACK to the information needed. The upper case task heading can be read at a glance and only when necessary, the text below it provides detailed information. Important specifications and warnings always stand out in bold type. REFERENCES References have been kept to a minimum. However, when they are required you are given the page to go to. SPECIFICATIONS Specifications are presented in bold type throughout the text to save time and help you never have to leave the procedure to look up your specs. All specifications are also found in Appendix A, specifications, for quick reference. WARNINGS, CAUTIONS, NOTES: • WARNINGS are presented in bold type, and indicate there is a possibility of injury to you or other people. • CAUTIONS are also presented in bold type, and indicate the possibility of damage to the components being repaired. • NOTES are separated from the text but do not appear in bold. They provide additional information to help you efficiently perform the repair.