AB-22 SRS AIRBAG — Replacement of Repair Wire for Front Airbag Sensor Miniature Screw driver HR197 HINT: You might find it easier if you use a miniature screwdriver as a guide as you insert wires into the sleeve. Crimping Tool Sleeve Color Marks HR198 (c) The crimping tool (AMP Part No. 169060-2) has color marks on it. Place the sleeve in the correct section of the tool according to the color of the sleeve itself. HINT: As the crimping tool, AMP ''Part No. 169060-2'' is convenient to use. "CLOSE HERE" Contact HR200 (d) With the center of the sleeve correctly placed between the crimping jaws, squeeze the crimping tool until either end comes into contact at the section marked by ''CLOSE HERE''. HINT: Check to see that the sleeve and wires are still in the correct position before closing the crimping tool ends with steady pressure. HR201 (e) Pull the joined wires to either end. Make sure that they are joined firmly by the sleeve. NOTICE: If the joined wires come loose the splice is defective, so replace the sleeve and repeat the procedure. "INS" Position HR202 (f) Crimp both ends of the sleeve with the crimping tool at the ''INS'' position.