
9. INSTALL NEW PADS
(a) Install anti-squeal shim No.1 to the pad.
(b) Install the pads onto each support plate.
HINT: Install the pads so the wear indicator is at the bottom side.
(c) Install the anti-squeal shim No.2 over shim No.1.
(d) Install the two anti-squeal springs.
NOTICE: Do not allow oil or grease to get on the rubbing face.
10. INSTALL CYLINDER
(a) Draw out a small amount of brake fluid from the reservoir.
(b) Press in piston with a hammer handle or an equivalent.
HINT: Always change the pad on one wheel at a time as there is a possibility of the opposite piston flying out.
(c) Insert the brake cylinder carefully so the boot is not wedged.
(d) Install and torque the installation bolt.
Torque: 370 kg-cm (27 ft-lb, 36 N-m)
11. INSTALL BRAKE HOSE BRACKET
Install the brake hose bracket and torque the two bolts.
Torque: 195 kg-cm (14 ft-lb, 19 N-m)
12. INSTALL FRONT WHEEL
13. CHECK THAT FLUID LEVEL IS AT MAX LINE