MANUAL TRANSMISSION — Assembly of Transmission MT-83 (c) Using a torx socket wrench, torque the screw plugs. Torque: 190 kg·cm (14 ft·lb, 19 N·m) 27. INSTALL MAGNET TO INTERMEDIATE PLATE 28. DISMOUNT INTERMEDIATE PLATE FROM VISE (a) Dismount the intermediate plate from the vise. (b) Remove the bolts, nuts and plate washers. 29. INSTALL TRANSMISSION CASE (a) Apply seal packing to the transmission case as shown. Seal packing: Part No.08826-00090, THREE BOND 1281 or equivalent (b) Align each bearing outer race, each fork shaft end and reverse idler gear shaft end with the case installation holes, and install the case. If necessary, tap on the case with a plastic hammer. 30. INSTALL BEARING SNAP RINGS Using snap ring pliers, install the two snap rings to the input shaft bearing and counter gear front bearing.