Car Won't Start After Clutch Replacement - Dirty Starter Signal Wire Connection

Electricalbeginner✓ OP Confirmed

Problem

After replacing the clutch, the car would not crank. All accessories worked normally but turning the key produced only a click (from the starter relay in the glove compartment area). The starter would not engage.

Car will not crank after clutch replacementSingle click heard from glove compartment area (starter relay) when turning keyAll accessories and electrical systems work normallyBattery fully chargedEngine turns freely by hand at crank pulley

Root Cause

The brown starter signal wire connector on the starter solenoid had a dirty or corroded connection. During the clutch replacement, the connector was disconnected and when reconnected it did not make proper electrical contact, preventing the starter relay signal from reaching the starter solenoid.

Confidence

High confidence — Original poster confirmed this resolved the issue

View Original Thread →Posted May 2005 on SupraForums.com