Electrical
fuel pump does not prime with ecu
Confirmed fixed in 17 forum threads. Open the originals on SupraForums for the full discussion.
gt35r 2jz-nat mk3 wont start. HELP!!!!Thread →
ecu receives no power after engine swap
32 posts
no power to ecuThread →
no power supply to ECU
26 posts
Ok, getting pist now..........Thread →
difficulty reinstalling ECU
24 posts
Question on Vf readings.....Thread →
ECU adjusting fuel mixture based on voltage reading
14 posts
A/F guage hookupThread →
connecting air/fuel ratio gauge signal to ECU
12 posts
How do I reset my ECU?Thread →
how to reset the ecu
12 posts
Mother F Fing 7m WireingThread →
ECU not receiving power
11 posts
Ecu mounting position?Thread →
unknown ECU mounting location after dash replacement
10 posts
FP to B+ wiring pathThread →
fuel pump does not prime with ecu
6 posts
Reset the ECU, now problems are backThread →
loss of power and efficiency after ecu reset
6 posts
Someone Help Asap!!! I'm In Trouble!!!Thread →
needs ecu reset after electrical issue
6 posts
Strange non starting issueThread →
no crank after ecu replacement
6 posts
Wierd problem with my 1jz ,Thread →
sensor issues on the ECU
5 posts
Need to Disconnect the Fuel Pump but not the ECU...How?Thread →
disconnecting fuel pump without disconnecting ecu
4 posts
Can't figure out how the ECU goes back inThread →
ECU installation difficulty
4 posts
Q on TimingThread →
ECU changes engine timing if not connected
3 posts
Another GTE starting thread. (searched and narrowed!)Thread →
no RPM signal to ECU after cranking
3 posts