SA–18 SUSPENSION AND AXLE – FRONT AXLE HUB 4. REMOVE INNER RACE (OUTSIDE) FROM AXLE HUB Using SST, remove the inner race from the axle hub. SST 09950–40010 SST R11078 5. REMOVE OIL SEAL Using SST, remove the oil seal from the steering knuckle. SST 09308–00010 SST SA3584 6. REMOVE BEARING FROM STEERING KNUCKLE (a) Using snap ring pliers, remove the snap ring. (b) Position the inner race above the bearing on the inner side. (c) Using SST and a press, remove the bearing from the steering knuckle. SST 09608–35014 (09608–06100) SST SA3587 FRONT AXLE HUB ASSEMBLY 1. INSTALL BEARING TO STEERING KNUCKLE (a) Using SST, install a new bearing. SST 09608–35014 (09608–06200) NOTICE: If the inner race and balls come loose from the bearing outer race, be sure to install them on the same side as before. (b) Using snap ring pliers, install the snap ring. 2. INSTALL OIL SEAL (a) Install the inner race (outside). (b) Using SST and a hammer, tap in a new oil seal until it is flush with the end surface of the steering knuckle. SST 09608–32010 (c) Coat MP grease to the oil seal lip. 3. INSTALL AXLE HUB TO STEERING KNUCKLE (a) Install the brake dust cover to the steering knuckle with the 4 bolts. Torque: 8 N·m (85 kgf·cm, 74 in·lbf) SST SA3683 SST R01024