23. INSTALL O-RING ON OVERDRIVE CASE 24. INSTALL CONVERTER HOUSING Install the two 12-mm bolts at B and four 10-mm bolts at A and tighten them. Torque: A bolts 345 kg-cm (25 ft-lb, 34 N-m) B bolts 580 kg-cm (42 ft-lb, 57 N-m) 25. INSTALL RACE ON OVERDRIVE CLUTCH Install the thrust washer, facing the lip side outward. 26. INSTALL THRUST BEARING ON FRONT OIL PUMP Coat the thrust washer with petroleum jelly and install the washer side toward the pump body together with the bearing. 27. INSTALL FRONT OIL PUMP (a) Install the oil pump gently through the two guide pins, being careful that the thrust washer does not fall out. (b) Coat the five set bolts with seal packing and finger tighten them. (c) Using a screwdriver, remove the SST, and install the two set bolts coated with seal packing. SST 09350-20013 (09362-30011) (d) Tighten the set bolts gradually and uniformly. Torque: 215 kg-cm (16 ft-lb, 21 N-m) 28. TIGHTEN TWO CENTER SUPPORT BOLTS Tighten the bolts alternately in 70 kg-cm (61 in.-lb, 6.9 N-m) increments. Torque: 260 kg-cm (19 ft-lb, 25 N-m) NOTE: First tigten the accumulator side bolt.