SR-12 STEERING — Steering Column Assembly with Tilt Steering INSTALLATION OF STEERING COLUMN ASSEMBLY (See page SR-1) 1. PLACE COLUMN AND SHAFT IN INSTALLED POSITION 2. INSTALL COLUMN BRACKET MOUNTING NUTS BY HAND 3. INSTALL STEERING COLUMN HOLE COVER PLATE Tighten the bolts. Torque: 130 kg·cm (9 ft·lb, 13 N·m) 4. TORQUE TWO COLUMN BRACKET MOUNTING NUTS Torque: 250 kg·cm (18 ft·lb, 25 N·m) 5. INSTALL COMBINATION SWITCH AND COLUMN COVER 6. INSTALL AIR DUCT AND INSTRUMENT LOWER PANEL 7. INSTALL INTERMEDIATE SHAFT (a) Install the column side first. (b) Install the rack housing side. (c) Install the two bolts and torque them. Torque: 350 kg·cm (25 ft·lb, 34 N·m) 8. CONNECT NEGATIVE CABLE TO BATTERY 9. INSTALL STEERING WHEEL (a) Position the front wheels straight ahead and install the steering wheel in the neutral position. (b) Tighten the nut. Torque: 350 kg·cm (25 ft·lb, 34 N·m) (c) Install the steering wheel pad.