ASSEMBLY OF OIL PUMP (See page LU-7) ASSEMBLY OIL PUMP (a) Install the drive shaft, spacer, key, shaft gear and snap ring. (b) Install the driven gear and pump cover with the five bolts. Torque: 75 kg-cm (65 in.-lb, 7.4 N·m) (c) Install the relief valve and spring in the cover, and screw on the relief valve plug. Torque: 375 kg-cm (27 ft-lb, 37 N·m) OPERATION CHECK OF OIL PUMP 1. CHECK PUMP OPERATION (a) Immerse the suction end of the pump into clean engine oil and turn the shaft counterclockwise. Oil should come out of the discharge hole. (b) Close the discharge hole with your thumb, and turn the shaft as before. The shaft should be difficult to turn. 2. INSTALL OIL PUMP STRAINER (a) Install a new O-ring to oil pump strainer. (b) Install the oil pump strainer with the two bolts. Torque: 130 kg-cm (9 ft-lb, 13 N·m) 3. INSTALL OIL PUMP OUTLET PIPE Install the oil pump outlet pipe with a new lock washer, gasket and the union bolt. Finger tighten the union bolt.