
Counter Gear and Reverse Idler Gear
COMPONENTS
Counter Gear Front Bearing
Snap Ring
Counter Gear
Reverse Idler Gear
Reverse Idler Gear Shaft
Counter Gear Rear Bearing
Thrust Washer
Needle Roller Bearing
Counter 5th Gear
No. 3 Hub Sleeve
Synchronizer Ring
No. 5 Gear
Spline Piece
◆ Non-reusable part
RN0252L
INSPECTION OF COUNTER GEAR
1. CHECK OIL CLEARANCE OF 5TH GEAR
(a) Install the spacer, counter 5th gear and needle roller bearings.
(b) Using a dial indicator, measure the counter 5th gear oil clearance.
Standard clearance: 0.015 — 0.068 mm
(0.006 — 0.0027 in.)
Maximum clearance: 0.16 mm (0.0063 in.)
If the clearance exceeds the limit, replace the gear, bearing or shaft.
2. REMOVE HUB SLEEVE NO.3 SHIFTING KEYS AND SPRINGS FROM COUNTER 5TH GEAR
Using a screwdriver, remove three shifting keys and two springs from counter 5th gear.
12-71
D4693D