21. STAKE DRIVE PINION NUT 22. INSTALL SIDE GEAR SHAFT OIL SEAL (a) Coat the oil seal lip with MP grease. (b) Using SST, drive in the oil seal until it is flush with the carrier end surface. SST 09608-10010 and 09608-35014 (09608-06020) 23. INSTALL SIDE GEAR SHAFT (a) Install a new snap ring to the side gear shaft. (b) Using SST, drive in the side gear shaft until it contacts the pinion shaft. SST 09520-24010 HINT: As the LSD cannot be checked visually, check that the shaft is fully inserted by confirming the should it makes when it is tapped. 24. MEASURE SIDE GEAR SHAFT RUNOUT Minimum lash runout: 0 mm (0 in.) Maximum radial runout: 0.2 mm (0.008 in.) If the runout is greater than the maximum, replace the side gear shaft. 25. INSTALL DIFFERENTIAL CARRIER COVER (a) Clean contacting surfaces of any residual packing material using gasoline or alcohol. (b) Apply seal packing to the carrier. Seal packing: Part No. 08826-00090, THREE BOND 1281 or equivalent HINT: Install the carrier cover within 3 minutes after applying seal packing.