(b) Apply MP grease to a new oil seal lip. (c) Using SST and a hammer, tap in the oil seal. SST 09214-60010 and 09506-35010 2. REPLACE CRANKSHAFT REAR OIL SEAL A. If the rear oil seal retainer is removed from the cylinder block: (a) Using a screwdriver and hammer, tap out the oil seal. (b) Using SST and a hammer, tap in a new oil seal. SST 09223-41020 (c) Apply MP grease to the oil seal lip. B. If the rear oil seal retainer is installed to the cylinder block: (a) Using a knife, cut off the lip of the oil seal as shown. (b) Using a screwdriver, pry out the oil seal. NOTICE: Be careful not to damage the crankshaft. Tape the screwdriver tip. (c) Check the oil seal lip contact surface of the crankshaft for cracks or damage. (d) Apply MP grease to a new oil seal lip. (e) Using SST and a hammer, tap in the oil seal. SST 09223-41020