14. INSTALL OIL HOLE COVER PLATE Install a new gasket and oil hole cover plate with the two bolts. 15. (7M-GE) INSTALL NEW OIL FILTER (See page LU-5) 16. INSTALL ENGINE MOUNTING BRACKETS 17. INSTALL FUEL RETURN PIPE SUPPORT Install a new insulator and fuel pipe support with the two nuts. Torque: 130 kg-cm (89 ft-lb, 13 N-m) 18. (7M-GE) INSTALL VACUUM CONTROL VALVE SET 19. INSTALL GROUND STRAP TO CYLINDER BLOCK 20. INSTALL WATER BY-PASS PIPE (a) Install a new gasket and water by-pass pipe to the timing belt case with the two nuts. Torque: 140 kg-cm (10 ft-lb, 14 N-m) (b) Install the water by-pass pipe to the cylinder block with the three bolts. Torque: 130 kg-cm (9 ft-lb, 13 N-m) 21. INSTALL CYLINDER HEAD (See steps 1 and 4 to 16 and 18 on pages EM-55 to 61) 22. INSTALL TIMING BELT (See steps 1 to 8, 10 to 12 and 16 on pages EM-28 to 31) 23. REMOVE ENGINE STAND 24. INSTALL REAR END PLATE Torque: 130 kg-cm (9 ft-lb, 13 N-m) 25. INSTALL FLYWHEEL OR DRIVE PLATE ON CRANKSHAFT (a) Install the flywheel or drive plate on crankshaft. (b) Apply a light coat of engine oil on the threads and under the bolt heads. (c) Install and uniformly tighten the bolts in several pass- es, in the sequence shown. Torque: 750 kg-cm (54 ft-lb, 74 N-m)