EG–130 ENGINE – ENGINE MECHANICAL 5. INSTALL REAR CENTER FLOOR CROSSMEMBER BRACE Torque: 28 N·m (290 kgf·cm, 21 ft·lbf) 6. INSTALL EXHAUST PIPE HEAT INSULATOR 7. INSTALL NO.2 FRONT EXHAUST PIPE Install a new gasket and the front exhaust pipe with 3 new nuts. Torque: 62 N·m (630 kgf·cm, 46 ft·lbf) 8. INSTALL EXHAUST PIPE ASSEMBLY (a) Install the hook of the tailpipe to the 2 rings on the tailpipe bracket. (b) Install the hook of the exhaust pipe to the 2 rings on the exhaust pipe brackets. (c) Install the pipe support bracket with the 2 bolts. Torque: 43 N·m (440 kgf·cm, 32 ft·lbf) (d) Install a new gasket and the No.2 front exhaust pipe to the front exhaust pipe with the 2 bolts and 2 new nuts. Torque: 58 N·m (590 kgf·cm, 43 ft·lbf) 9. INSTALL SUB HEATED OXYGEN SENSOR Install a new gasket, the oxygen sensor and sensor cover with the 2 nuts. Torque: 18 N·m (180 kgf·cm, 13 ft·lbf) 10. M/T: INSTALL CLUTCH RELEASE CYLINDER AND GROUND STRAP (a) Install the clutch release cylinder with the 2 bolts. Torque: 13 N·m (130 kgf·cm, 9 ft·lbf) (b) Connect the clutch line tube with the bolt. Torque: 37 N·m (380 kgf·cm, 27 ft·lbf) (c) Install the ground strap with the bolt. Torque: 37 N·m (380 kgf·cm, 27 ft·lbf) 11. CONNECT ENGINE WIRE TO CABIN (a) Push in the engine wire through the cowl panel. NOTICE: Be careful not to damage the engine wire. (b) Connect the 2 connectors to the connector cassette. (c) Connect the connector to the instrument panel wire connector. (d) Connect the 2 connectors to the ECM. (e) Connect the connector to the TRAC ECU. (f) Insert the ECM bracket into the stay on the floor panel. (g) Install the ECM with the nut. (h) Install the ECM protector with the 2 nuts. (i) Install the floor carpet. (j) Install the scuff plate. 12. M/T: INSTALL UPPER CONSOLE PANEL, SHIFT LEVER BOOTS AND HOLDING BOLTS Insert P11086