PR–14 PROPELLER SHAFT – PROPELLER SHAFT Matchmarks R06865 (d) Temporarily install the center support bearing set bolts with the adjusting washers. HINT: Use the adjusting washers which were removed. (e) Align the matchmarks and install the propeller shaft on the differential with the 3 bolts, washers and nuts. NOTICE: Bolts should be inserted from the propeller shaft side. Torque: 79 N·m (805 kgf·cm, 58 ft·lbf) 120° Phasemarks R07096 If using a new propeller shaft w/ Phasemarks: Install the propeller shaft phasemarks and differential phase- marks so that their respective alignment phasemarks match. If the propeller shaft phasemarks and differential phase- marks do not align, install the propeller shaft and differential alignment phasemarks as close together as possible. w/o Phasemarks: Install the propeller shaft. (See page PR–13) 12.5 ± 1 mm (0.492 ± 0.04 in.) R08278 Z10404 (f) Torque the 2 center support bearing set bolts. Torque: 49 N·m (500 kgf·cm, 36 ft·lbf) HINT: Adjust the center support bearing to keep the dimen- sion, as shown with the vehicle in the unladen condition. Under the same condition, check if the center line of the cen- ter support bearing is at right angles to the shaft axial direc- tion. SST R06864 (g) Using SST, torque the adjusting nut. SST 09922–10010 Torque: 50 N·m (515 kgf·cm, 37 ft·lbf) HINT: Use torque wrench with a fulcrum length of 34.5 cm (13.6 in.)