RS–35 SUPPLEMENTAL RESTRAINT SYSTEM – CENTER AIRBAG SENSOR ASSEMBLY • Never use SRS parts from another vehicle. When replacing parts, replace with new parts. • Never reuse the center airbag sensor assembly involved in a collision when the airbag has deployed. • Never repair a sensor in order to reuse it. 1. REMOVE CONSOLE PANEL UPPER AND CONSOLE BOX (See page BO–44) 2. REMOVE CENTER AIRBAG SENSOR ASSEMBLY (a) Disconnect the connector. NOTICE: Removal of the connector is done with the sensor assembly installed. (b) Using a torx wrench, remove the 4 screws and the center airbag sensor assembly. Torx wrench: T40 (Part No. 09042–00020 or locally manufactured tool) 3. INSTALL CENTER AIRBAG SENSOR ASSEMBLY (a) Using a torx wrench, install the center airbag sensor assembly with the 4 screws. Torx wrench: T40 (Part No. 09042–00020 or locally manufactured tool) Torque: 21 N·m (210 kgf·cm, 15 ft·lbf) (b) Connect the connector. NOTICE: • Installation of the connector is done with the sensor assembly installed. • Make sure the sensor assembly is installed to the specified torque. • If the sensor assembly has been dropped, or there are cracks, dents or other defects in the case, bracket or connector, replace the sensor assembly with a new one. • When installing the sensor assembly, take care that the SRS wiring does not interfere with other parts and is not pinched between other parts. • After installation, shake the sensor assembly to check that there is no looseness. 4. INSTALL CONSOLE BOX AND CONSOLE PANEL UPPER (See page BO–44)