13. CONNECT ENGINE WIRE TO COWL PANEL 14. INSTALL A/C COMPRESSOR (a) Using a torx socket (E10), install the stud bolt and and compressor. Torque: 26 N·m (265 kgf·cm, 19 ft·lbf) (b) Connect the compressor connector. (c) Temporarily install the compressor with nut and 3 bolts. (d) Alternately tighten the bolt and nut. Torque: 52 N·m (530 kgf·cm, 38 ft·lbf) 15. INSTALL PS PRESSURE TUBE 16. INSTALL PS PUMP (a) Install the pump bracket with the 3 bolts. Torque: A 58 N·m (590 kgf·cm, 43 ft·lbf) B 39 N·m (400 kgf·cm, 29 ft·lbf) (b) Install the pump housing with the 2 bolts. Torque: 58 N·m (590 kgf·cm, 43 ft·lbf) (c) Connect these hoses: • Air hose to throttle body • Air hose to air intake chamber 17. CONNECT FUEL HOSES (a) Connect the fuel return hose to the fuel return pipe. (b) Install the fuel return hose to the clamp of the dipstick guide. (c) Install the fuel inlet hose with 2 new gaskets and the union bolt. Torque: 29 N·m (300 kgf·cm, 22 ft·lbf) 18. CONNECT WIRES AND CONNECTORS 19. CONNECT EVAP HOSE 20. CONNECT BRAKE BOOSTER VACUUM HOSE 21. CONNECT HEATER WATER HOSES 22. INSTALL CHARCOAL CANISTER 23. INSTALL WATER PUMP PULLEY, FAN, FLUID COUPLING ASSEMBLY AND DRIVE BELT (See step 10 in water pump installation in Cooling System) 24. M/T: INSTALL DRIVE BELT TENSIONER DAMPER (See step 19 timing belt installation) 25. INSTALL AIR CLEANER AND MAF METER ASSEMBLY 26. INSTALL NO.1 AIR HOSE 27. CONNECT CONTROL CABLES TO THROTTLE BODY 28. FILL WITH FUEL 29. FILL WITH ENGINE OIL 30. START ENGINE AND CHECK FOR LEAKS P 11527 209735