SA–52 SUSPENSION AND AXLE – REAR DRIVE SHAFT 7. INSTALL NEW END COVER (a) Pack grease into the end cover. Grease capacity: 50–55 g (0.11–0.12 lb, 1.8–1.9 oz.) (b) Remove grease from the surface of the inboard joint facing the cover. (c) Glue on a new gasket, with the side with adhesive on it facing toward the outer race side of the inboard joint. (d) Align the bolt holes of the cover with those of the inboard joint. (e) Install the 6 hexagon bolts and washer from the end cover side. (f) Install the 6 nuts to the boot side. (g) Using a 10 mm hexagon wrench, tighten the bolts. Do this in the order shown, and repeat several times. (h) Check that the claw of the end cover touches the inboard joint. 8. CHECK DRIVE SHAFT Check that operation of the joint is smooth within the sliding region in the axial direction. HINT: If a large angle is used for the cross–groove type joint, the joint will feel like it is catching, but this does not indicate an abnormality. X6285 Z04028 R07026 R05813