
INSPECTION PROCEDURE
1 Check output condition of diagnostic trouble code 51.
P Setting the test mode.
(1) Turn ignition switch OFF.
(2) Connect terminals TE2 and E1 of DLC2.
(3) Turn ignition switch ON.
(For checking terminal IDL, disconnect the vacuum hose from the throttle body, then apply vacuum to the throttle opener (See page EG–219)).
(For checking terminal A/C, start the engine.)
(4) Connect terminals TE1 and E1 of DLC1 or DLC2.
C Check if code "51" is output by the malfunction indicator lamp.
OK
Condition Code
Park/Nuetral Posi- P or N position Normal*
tion Switch (PNP) R,D, 2 or L position 51*
Throttle Position Accelerator pedal Normal*
Sensor (IDL1) released
Accelerator pedal 51*
depressed
A/C Switch (A/C) A/C SW ON 51
A/C SW OFF Normal
*: Before the STA signal is input (ST is not ON), diagnostic trouble code 43 is also output.
Hint Diagnostic trouble code 42 is output with vehicle speed 5 km/h (3 mph) or below.
CHECK
FI6914
OK NG IDL1...Go to step [2].
PNP....Go to page EG–463.
A/C....Go to step [3].
Proceed to next circuit inspection shown on matrix chart (See page EG–408).