BO–32 BODY – WINDSHIELD NOTICE: When separating the glass, take care not to damage the paint and interior and exterior ornaments. To prevent scratching the instrument panel when removing the windshield, place a plastic sheet between the piano wire and instrument panel. (c) Cut the adhesive by pulling the piano wire around it. (d) Remove the glass. NOTICE: Leave as much of the adhesive on the body as possible when cutting off the glass. BO1689 Adhesive BO4420 WINDSHIELD INSTALLATION 1. CLEAN AND SHAPE CONTACT SURFACE OF BODY (a) Using a knife, cut away any rough areas on the body. HINT: Leave as much of the adhesive on the body as possible. (b) Clean the cutting surface of the adhesive with a piece of shop rag saturated in cleaner. HINT: Even if all the adhesive has been removed, clean the body. ND9043 2. INSTALL SPACERS Install the spacers to the body as shown in the illustration. BO5231 3. CLEAN REMOVED GLASS (a) Using a scraper, remove the adhesive sticking to the glass. (b) Clean the glass with cleaner. NOTICE: Do not touch the glass after cleaning it. Mark Double Stick Tape N09471 4. INSTALL STOPPERS (a) Remove adhesive cover from stopper. (b) Position the stopper on the edge of the glass as shown on the illustration. (c) Break in the protruding part of the stopper.