MT1–10 W58 MANUAL TRANSMISSION – ASSEMBLY REMOVAL AND INSTALLATION 11. REMOVE CLUTCH RELEASE CYLINDER AND GROUND CABLE (a) Remove the 2 bolts and clutch release cylinder. Torque: 13 N·m (130 kgf·cm, 9 ft·lbf) (b) Remove the bolt, ground cable and flexible hose bracket. Torque: 37 N·m (380 kgf·cm, 27 ft·lbf) 12. REMOVE STARTER (a) Remove the nut and disconnect the starter wire. (b) Disconnect the starter wire connector. (c) Remove the 2 bolts and starter. Torque: 39 N·m (400 kgf·cm, 29 ft·lbf) 13. DISCONNECT BACK–UP LIGHT SWITCH CONNECTOR 14. DISCONNECT VEHICLE SPEED SENSOR CONNECTOR G04108 208964 15. REMOVE TRANSMISSION MOUNTING BOLTS Remove the 3 transmission mounting bolts. Torque: Bolt A: 72 N·m (730 kgf·cm, 53 ft·lbf) Bolt B: 37 N·m (380 kgf·cm, 27 ft·lbf) 16. JACK UP TRANSMISSION SLIGHTLY Using a transmission jack, support the transmission. 17. REMOVE REAR ENGINE MOUNTING MEMBER (a) Remove the 4 bolts and nuts. Torque: Nut: 13 N·m (135 kgf·cm, 10 ft·lbf) Bolt: 25 N·m (260 kgf·cm, 19 ft·lbf) (b) Remove the rear engine mounting member. 18. REMOVE ENGINE REAR MOUNTING Remove the 3 bolts and engine rear mounting from the transmission. Torque: 25 N·m (250 kgf·cm, 18 ft·lbf) G04794 19. REMOVE TRANSMISSION (a) Remove the 3 remaining transmission mounting bolts. Torque: 72 N·m (730 kgf·cm, 53 ft·lbf) (b) Lower the engine rear side and remove the transmission from the engine.